![]() I have disconnected the Motor and Testing again the servo: There is big problem: It work like the Transmitter is in Mode 1 Configuration. I have'nt undertand anything, it's the first time it would be appeared (after about 5 flights only, I'm begginer) Results: My New Carbon blades, the flybar and some teath of the main gear -> broken. And the helicopter has taking off and crashed out few 10s after. But yesterday when I have checked servos (with the Motor connected to ESC) before starting Flying, The motor has starting up when moving the Governor stick from Lower position to the center position. ![]() ![]() I'm explain you: Last Week-End, I have checked my BELT CP2 and it was OK to play this Week. I have just had a big problem yesterday with my BELT CP2 Helicopter where the ESKY ET6i transmitter could be the origin. Hello First, a special thanks to Nuttcaze for all informations and videos about the BELT CP2 Helicopter. I just bought a Belt CP, haven't flown it yet though. DRUSS, Just wanted to throw a few more KUDOS at ya. ![]() Esky Transmitter Manual and Tips, now includes BELT CP MANUAL. Esky Helicopters - Esky Transmitter Manual and Tips, now includes BELT CP MANUAL. Esky Helicopters - Esky Transmitter Manual and Tips, now includes BELT CP MANUAL - I've noticed there are a lot of posts lately on what does this.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |